Setting Up A Computer As A File Server - Canon IMAGERUNNER 4570 Network Manual

Setting Up a Computer as a File Server

To send data from the machine to a computer on your network, you need to specify
the settings of the computer for receiving data.
This section describes how to set up a computer as a file server.
IMPORTANT
•
You can only send data from the machine if the optional equipment is installed. For the
equipment needed, see "Optional Equipment and System Environment Requirements,"
4
on p. 1-2.
•
To send a file to the NetWare server, make the following NetWare settings of the
machine. For instructions on how to specify the protocol settings, see "Protocol Settings,"
on p. 4-9.
- <NetWare>: [On]
- The Frame Type drop-down list: Frame type suitable for your environment
•
This section describes only the procedures for setting up a computer receiving data sent
from the machine. To send data from the machine to a server on the network, you must
enter an address setting from the control panel. For instructions on how to specify
recipient address settings, see Chapter 2, "Basic Sending Methods," in the Sending and
Facsimile Guide.
•
In some environments, additional detailed settings, such as authority settings, may be
required. For details, consult the network manager of the environment you are using.
1
2
3
4-18

Setting Up a Computer as a File Server

Log in to NetWare as Administrator (or as a user of equivalent
authority).
Set up the users and passwords for sending data from the
machine.
Enter a user name, and a password not longer than 24 alphanumeric characters.
Create a directory to be used for recipient addresses, and
then enable read access and write access by the users who
will be sending data.