Transport-Mode - Cisco ASR 9000 Series Command Reference Manual

transport-mode

transport-mode

To specify the transport mode for a 10-Gigabit Ethernet interface, use the transport-mode command in
interface configuration mode. To return to the default mode, use the no form of this command.
transport-mode {wan| otn bit-transparent {opu1e| opu2e}}
no transport-mode {wan| otn bit-transparent {opu1e| opu2e}}
Syntax Description
wan
otn bit-transparent
opu1e
opu2e
Command Default
The interface is in LAN mode. Neither WAN mode or OTN mode is configured.
Command Modes
Interface configuration
Command History
Release
Release 3.9.0
Usage Guidelines
Three modes are supported for a 10-Gigabit Ethernet interface: LAN, WAN, or OTN on these Ethernet line
cards and Modular Port Adaptors (MPAs):
• 2-Port 10-Gigabit Ethernet, 20-Port Gigabit Ethernet Combination line card (A9K-2T20GE-B and
• 8-Port 10-Gigabit Ethernet line card (A9K-8T-L, -B, or -E)
• 16-Port 10-Gigabit Ethernet SFP+ line card (A9K-16T/8-B and A9K-16T/8-B+AIP)
• 24-Port 10-Gigabit Ethernet line card (A9K-24X10GE-SE/TR)
• 36-Port 10-Gigabit Ethernet line card (A9K-36X10GE-SE/TR)
• 2-Port 10-Gigabit Ethernet Modular Port Adaptor (A9K-MPA-2x10GE)
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
70
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
Configures the interface for 10GBASE-W WAN SONET/SDH (9.95328Gb/s)
transport.
Configures the interface for 10-Gigabit Ethernet over Optical Transport Network
(ITU-T G.709) with 10GBASE-R transparently mapped into OTU-2.
Configures the interface for 10GBASE-R over OPU1e without fixed stuffing
(11.0491Gb/s).
Configures the interface for 10GBASE-R over OPU2e with fixed stuffing
(11.0957Gb/s)
A9K-2T20GE-L)
Modification
This command was introduced.