Pm Optics Threshold - Cisco ASR 9000 Series Command Reference Manual

pm optics threshold

pm optics threshold
To configure performance monitoring thresholds on the optics layer, use the pm optics threshold command
in DWDM configuration mode. To return to the default state, use the no form of this command.
pm {15-min| 24-hour} optics threshold {lbc| opr| opt}{max| min} threshold
no pm {15-min| 24-hour} optics threshold {lbc| opr| opt} {max| min} threshold
Syntax Description
15-min
24-hour
lbc
opr
opt
max
min
threshold
Command Default
No thresholds are configured.
Command Modes
DWDM configuration
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To display performance monitoring information for the optics layer, use the show controller dwdm pm
optics command.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
38
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
Configures the performance monitoring thresholds for 15-minute intervals.
Configures performance monitoring thresholds for 24-hour intervals.
Laser bias current.
Optical power on the unidirectional port.
Transmit optical power in dBm.
Indicates that the threshold is for the maximum value of the parameter.
Indicates that the threshold is for the minimum value of the parameter.
Threshold for the performance monitoring parameter.
Modification
This command was introduced.