Juniper T320 Manual page 74

T320 Core Router Interface Module Reference
Software features
Cables and connectors
LEDs
58
Circuit cross-connect (CCC) for leveraging ATM access networks
User-configurable virtual circuit (VC) and virtual path (VP) support
Support for idle cell or unassigned cell transmission
OAM fault management processes alarm indication signal (AIS), remote defect indication
(RDI) cells, and loop cells
Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP
Local and remote loopback
ATM Inverse Address Resolution Protocol (ARP), which enables routers to automatically learn
the IP address of the router on the far end of an ATM permanent virtual circuit (PVC)
Simple Network Management Protocol (SNMP):
Management Information Base (MIB) 2 (RFC 1213)
ATM MIB (RFC 1695)
SONET MIB
Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate (CBR)
traffic shaping
Per-VC or per-VP traffic shaping
Support for F4 OAM cells
Support for 16 bit VCI range
Duplex SC/PC connector (RX and TX)
SONET/SDH OC3/STM1 fixed transceivers:
Multimode
Intermediate reach (IR-1)
Optical interface specifications—see
on page 40
One tricolor per port:
Off—Not enabled
Green—Online with no alarms or failures
Yellow—Online with alarms for remote failures
Red—Active with a local alarm; router has detected a failure
"SONET/SDH OC3/STM1 Optical Interface Specifications"
Copyright © 2015, Juniper Networks, Inc.