Juniper T320 Manual page 135

Software features
Cables and connectors
Copyright © 2015, Juniper Networks, Inc.
Intelligent handling of oversubscribed traffic
Optical diagnostics and related alarms
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
Virtual Router Redundancy Protocol (VRRP) support
Hierarchical shaping
Fine-grained queuing and shaping per logical interface at both ingress and egress
802.1q virtual LANs (VLANs)
VLAN stacking and rewriting
Channels defined by two stacked VLAN tags
Multiple tag protocol identifiers (TPID) support
IP service for nonstandard TPID and stacked VLAN tags
802.1p rewrite per channel
Flexible mapping of channels and scheduler resources at both ingress and egress
Flexible Ethernet encapsulation
MAC learning, policing, accounting, and filtering
You can install any transceiver supported by the PIC.
NOTE: Do not install SONET/SDH SFPs in the Gigabit Ethernet port. The port will not recognize
the SFP.
Fiber-optic SFP transceivers:
Duplex LC/PC connector (Rx and Tx)
Small form-factor pluggable (SFP) transceivers:
1000Base-LH (model number: SFP-1GE-LH)
1000Base-LX (model number: SFP-1GE-LX)
1000Base-SX (model number: SFP-1GE-SX)
Optical interface specifications—see
Specifications" on page 31
1000Base-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)—See
"Fast Ethernet and Gigabit Ethernet Bidirectional SFP Optical Interface Specifications" on
page 27
Copper transceivers:
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
1000Base-T (model number: SFP-1GE-T)
Copper interface specifications—see Gigabit Ethernet 1000BASE-T Copper Interface
Specifications
Chapter 9: Ethernet IQ2 PIC Descriptions
"Gigabit Ethernet 1000BASE Optical Interface
119