10-Gigabit Ethernet Eol Pic (T320 Router) - Juniper T320 Manual

Core router interface module reference
Hide thumbs Also See for T320:
Table of Contents

Advertisement

10-Gigabit Ethernet EOL PIC (T320 Router)

Software release
Description
Hardware features
Software features
Cables and connectors
LEDs
Copyright © 2015, Juniper Networks, Inc.
Junos OS Release 5.4 and later
One 10-Gigabit Ethernet port
Power requirement: 0.74 A @ 48 V (35.5 W)
Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network
High-performance throughput at speeds up to 10 Gbps
Full-duplex mode
Maximum transmission units (MTUs) up to 9192 bytes
64 source MAC address filters
960 destination MAC filters
Virtual Router Redundancy Protocol (VRRP) support
802.1Q virtual LANs (VLANs) support
802.3ae link aggregation support
RMON EtherStats
Duplex SC/PC connector (RX and TX)
10GBASE-LR fixed transceiver
10-Gigabit Ethernet 10GBASE Optical Interface Specifications on page 34
Status LEDs, one bicolor:
Off—PIC not enabled
Green—PIC is operating normally
Red—PIC has an error or failure
Port LEDs, one pair:
Link—If green, the port is online; if there is no light, the port is down
RX—If flashing green, the port is receiving data; if there is no light, the port might be on, but is
not receiving data
Chapter 13: End-of-Life PIC Descriptions
169

Advertisement

Table of Contents
loading

Table of Contents