Juniper T320 Manual page 137

Hardware features
Software features
Cables and connectors
Copyright © 2015, Juniper Networks, Inc.
High-performance throughput
WAN-PHY mode at 9.953 Gbps
LAN-PHY mode at 10.3125 Gbps
Full-duplex mode
Large maximum transmission units (MTUs) of up to 9192 bytes
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
Configurable WAN-PHY mode options:
loopback
mpls
path-trace
trigger
Virtual Router Redundancy Protocol (VRRP) support
Hierarchical shaping
Fine-grained queueing and shaping per logical interface at both ingress and egress
802.1q virtual LANs (VLANs)
VLAN stacking and rewriting
Channels defined by two stacked VLAN tags
Multiple tag protocol identifiers (TPID) support
IP service for nonstandard TPID and stacked VLAN tags
802.1p rewrite per channel
Flexible mapping of channels and scheduler resources at both ingress and egress
Flexible Ethernet encapsulation
MAC learning, policing, accounting, and filtering
You can install any transceiver supported by the PIC.
Fiber-optic 10–Gigabit small form-factor pluggable (XFP) transceivers:
Duplex LC/PC connector (Rx and Tx)
10-Gigabit Ethernet XFP transceivers:
10GBASE-S (model number: XFP-10G-S)
10GBASE-L (model number: XFP-10G-L-OC192-SR1 )
10GBASE-E (model number: XFP-10G-E-OC192-IR2 )
10GBASE-Z (model number: XFP-10G-Z-OC192-LR2 )
Optical interface specifications—see
Specifications" on page 34
Chapter 9: Ethernet IQ2 PIC Descriptions
"10-Gigabit Ethernet 10GBASE Optical Interface
121