Sonet/Sdh Oc192C/Stm64 Pic (T320 Router) - Juniper T320 Manual

T320 Core Router Interface Module Reference

SONET/SDH OC192c/STM64 PIC (T320 Router)

Software release
Description
Hardware features
Software features
Cables and connectors
154
Junos OS Release 5.4 and later (Type 3)
One OC192 port
Power requirement: 0.45 A @ 48 V (21.6 W)
Multiplexing and demultiplexing
Rate policing on input
Rate shaping on output
Packet buffering, Layer 2 parsing
SONET/SDH framing
Link aggregation
Alarm and event counting and detection
Dual-router automatic protection switching (APS)
Multiprotocol Label Switching (MPLS) fast reroute
Encapsulations:
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Frame Relay
High-Level Data Link Control (HDLC)
Point-to-Point Protocol (PPP)
Very short reach (VSR 1): 12-ribbon multimode fiber with MTP connector (Rx and Tx)
Optical interface specifications—see
Specifications" on page 47
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links,
take the PIC offline until you are ready to establish a link to another device. For information about
taking a PIC offline, see the
request chassis pic offline
"SONET/SDH OC192/STM64 Optical Interface
command in the
Copyright © 2015, Juniper Networks, Inc.
CLI Explorer .