JRC JCY-1800 Installation Manual page 43

5
Lay the RGB cable.
Fix the RGB cable by four cable clamps in the ceiling panel section, and connect with the "RGB1" D-SUB
connector of FGB.
Shorten the RGB cable length of the FGB side for not touching against door of RCU.
6
Connect the LAN cable between the FGB and the MCB.
Connect the LAN cable to any LAN port of VDR-LAN on the MCB.
JCY-1800/1850 VDR/S-VDR Installation Guide
RGB cable
Cable clamp: 2 points
Cable clamp: 2 point
Cable length is adjusted so that it may not
interfere with the door of RCU.
33
2. Installation Procedures
LAN cable
DOC No. 7ZPJD0387C