JRC JCY-1800 Installation Manual page 121

Symptom
ERROR CODE: "33__"
lights up.
ERROR CODE: "34__"
lights up.
ERROR CODE:
"40__"/"41__"/
"42__" lights up.
ERROR CODE: "70__" /
"71__" lights up.
ERROR CODE: "72__"
lights up.
ERROR CODE: "73__" /
"76__" lights up.
ERROR CODE: "74__"
lights up.
ERROR CODE: "75__"
lights up.
ERROR CODE: "12__"
lights up.
Causes
GPS is faulty or setting error on the Main Control
Board
An internal battery for a Real Time Clock IC has run
out of the life.
Fault in the Audio Recording Board
Fault in RGB signals from a RADAR
70__: CH1
71__: CH2
Faulty wiring between the Frame Grabber Board
and the Main Control Board
Fault in the Frame Grabber Board
Fault in the Main Control Board
Fault on setting up the Frame Grabber Board
Fault in the Frame Grabber Board
The fan of NWP-46 is out of order.
Faulty wiring between the Power Supply Unit and
the Main Control Board
JCY-1800/1850 VDR/S-VDR Installation Guide
Check the GPS.
If the GPS is error-free, contact us.
Check the receiving data and setting data by
the Maintenance software.
Check that ZDA or RMC sentence is received
and recorded from CH which is connected to
a main GPS.
Exchanging the lithium battery on the MCB
(CDJ-2304).
Reboot the Recording Control Unit, and see if
the symptom persists
us.
Fault in the ARB (CHA-387)
Exchange the ARB.
Check the RADR.
If an image is displayed on the screen, check
the wiring between the RADAR and the
Recording Control Unit.
In the case of a Chart Radar, check whether
the image signals is outputted.
Check the wiring between the Frame Grabber
Board and the Main Control Board.
Check the LAN communication by a PING
command.
MCB: PING 192.168.110.3
FGB: PING 192.168.110.151
In case a no response
MCB (CDJ-2304) :
Fault in a circuit board or setting data
FGB (CKA-137) :
Fault in a circuit board or setting data
Reboot the Recording Control Unit, and see if
the symptom persists
us.
FGB (CKA-137) :
Fault in a circuit board or setting data
Exchange the FGB.
Reboot the Recording Control Unit, and see if
the symptom persists
us.
Upload a configuration file which is set up for
a connecting Radar unit to the FGB by the
Maintenance software.
Reboot the Recording Control Unit, and see if
the symptom persists
us.
Exchange a fan in the NWP-46.
Reboot the Recording Control Unit, and see if
the symptom persists
us.
Check the W103 cable connection.
111
8. Troubleshooting
Actions to be taken
or not. If yes,
contact
or not. If yes,
contact
or not. If yes,
contact
or not. If yes,
contact
or not. If yes,
contact
DOC No. 7ZPJD0387C