Configuration Tools And Interfaces For St 700 Basic Transmitter; Overview; Pre-Requisites; Application Design, Installation, Startup And Operation - Honeywell ST 700 User Manual

15 Configuration Tools and Interfaces for

15.1 Overview

This section describes the tools and interfaces involved in configuring a new ST 700 Basic SmartLine
Pressure Transmitter for HART operation. The information in this section also applies to adjusting the
configuration of a Transmitter that has been in operation and updating one that is currently in
operation.

15.2 Pre-requisites

The information and procedures in this manual are based on the assumption that personnel
performing configuration and calibration tasks are fully qualified and knowledgeable in the use of the
Honeywell MC Toolkit or MCT404/202. The name MC Toolkit or Toolkit and MCT404/202 are used
interchangeably as MCT404/202 is the model name for the Honeywell MC Toolkit product.
Furthermore, we assume that the reader is intimately familiar with the ST 700 Basic SmartLine
Pressure Transmitter and thoroughly experienced in the type of process application targeted for
Transmitter deployment. Therefore, detailed procedures are supplied only in so far as necessary to
ensure satisfactory completion of configuration tasks.

15.3 Application Design, Installation, Startup and Operation

The ST 700 SmartLine Pressure Transmitters User's Manual, Document # 34-ST-25-44, provides the
details for application design, installation, and startup; see Table 33 for topics.
ST 700 SmartLine Pressure Transmitters User's Manual
Section 2.
Application Design
Safety and accuracy
Diagnostics messages
Design consideration

15.3.1 Organization

This information in this section is arranged in the following sequence:

MC Toolkit participation in ST 700 Transmitter Setup and Configuration:
o Physical circuit connections
o Application components
o Configuration for Analog-HART operation

ST 700 Transmitter:
o Standard Displays (2-buttons)
o Health indications
o Optional 2 Reed switches
o
Ability to be configured and operate in a process system
Page 118
ST 700 Basic Transmitter
Table 33 – User Manual Related Topics
Section 3. Installation and Startup
Site evaluation
Toolkit issues
Display installation concerns
Transmitter mounting & zero-correction
Piping & wiring
Startup tasks and procedures
ST 700 Series HART/DE Option User's Manual
Section 4. Operation
Three-button option (Basic
Display)
Two-button option (Standard
Display)
Failsafe direction setup
Monitoring displays
Revision 4.0