Honeywell ST 700 User Manual page 148

Online/Device
Setup/Basic Setup/
Device Information
(Continued ...)
Page 134
Device ID
Final Asmbly num
Universal rev
Fld dev rev
Software rev
Loop mA
PV Units
PV Damping
SV Units
Write Protect
ST 700 Series HART/DE Option User's Manual
Displays the HART unique long address of the ST
700 Pressure Transmitter
Displays the final assembly number of the ST 700
Pressure Transmitter
Displays the HART Universal Revision of the ST
700 Pressure Transmitter
Displays Field Device Revision of the ST 700
Pressure Transmitter
Displays the Electronics Board Software Revision of
the ST 700 Pressure Transmitter
Click the Loop Current Mode configuration:

Enable: enables loop current mode (analog
output will operate as a 4 to 20mA signal
consistent with the transmitter output)

Disable: disables loop current mode
(analog output will be fixed at 4mA)
Click one of the pre-programmed engineering units.
ST 700 Transmitters with inches of water ranges
are factory calibrated using pressure referenced to
o o
39.2 F (4 C). Pressure readings can be displayed in
the following engineering units:
inH O inHg
2
mmH O mmHg
2
bar mbar
2
kg/cm Pa
torr atm
o
inH O @ 4 C mmH
2
o
60 F cmH2O
Enter a value for damping of the device output.
Entries may be any value from 0.00 to 32.00
seconds.
Click the relevant unit for measurement of the
Secondary Variable (Meter Body Temperature).
The available measurements are:
o o o
C , F, R, Kelvin
Displays the current configuration of the write
protect function. Write Protect is "Enabled" if either
the write protect jumper on the electronics board is
in the ON position or the firmware write protect has
been enabled.
ftH O
2
psi
2
g/cm
kPa
MPa
o
O@4 C inH O @
2 2
mH2O
Revision 4.0