Rep 3.1.1: Control Panel - Xerox 450c Service Manual

REP 3.1.1: Control Panel

Parts List: 4.1
1. Perform the following:
a. REP 1.1: WorkCentre Cover on page 4-3
2. Disconnect the ground wires on either side of
the base of the scanner. This is best done at
the chassis connection.
3. Loosen the ground wire from the analog
circuit board. Replace the screw, but do not
tighten.
4. Disconnect the wire harness from connector
J3 (labeled OPE) on the scanner relay board.
5. Tilt the Control Panel forward until it is
vertical, then lift out of the slots.
Xerox WorkCentre 450c/450cp Service Manual
www.printcopy.info
Page 4-27