Restoring Factory-Default Settings; Important Point To Remember - Dell C9000 Series Networking Configuration Manual

BOOT_USER mode
BOOT_USER# boot change secondary
BOOT_USER# boot change default
5 Reboot the chassis.
BOOT_USER mode
reload

Restoring Factory-Default Settings

When you restore factory-default settings on a switch, the existing NVRAM settings, startup configuration, and
all configured settings are deleted.
To restore the factory-default settings, enter the restore factory-defaults {chassis | domain |
linecard | pe | rpm } command in EXEC Privilege mode.
CAUTION: There is no undo for this command.

Important Point to Remember

• After the restore is complete, a switch reloads immediately.
The following example shows how the restore factory-defaults command restores a switch to its factory
default settings.
Dell# restore factory-defaults chassis nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing
* persistent settings (stacking, fanout, etc.)
* After restoration the unit(s) will be powercycled immediately.
* Proceed with caution !
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
Power-cycling the unit(s).
....
*
*
*
*
Switch Management 89