Configure Bfd For Vrrp - Dell C9000 Series Networking Configuration Manual

Prefixes accepted 0 (consume 0 bytes), withdrawn 0 by peer, martian prefixes
ignored 0
Prefixes advertised 0, denied 0, withdrawn 0 from peer
Connections established 1; dropped 0
Last reset never
Local host: 2.2.2.3, Local port: 63805
Foreign host: 2.2.2.2, Foreign port: 179
E1200i_ExaScale#
R2# show ip bgp neighbors 2.2.2.3
BGP neighbor is 2.2.2.3, remote AS 1, external link
Member of peer-group pg1 for session parameters
BGP version 4, remote router ID 12.0.0.4
BGP state ESTABLISHED, in this state for 00:05:33
...
Neighbor is using BGP neighbor mode BFD configuration
Peer active in peer-group outbound optimization
...
R2# show ip bgp neighbors 2.2.2.4
BGP neighbor is 2.2.2.4, remote AS 1, external link
Member of peer-group pg1 for session parameters
BGP version 4, remote router ID 12.0.0.4
BGP state ESTABLISHED, in this state for 00:05:33
...
Neighbor is using BGP peer-group mode BFD configuration
Peer active in peer-group outbound optimization
...

Configure BFD for VRRP

When using BFD with VRRP, the VRRP protocol registers with the BFD manager. BFD sessions are established
with all neighboring interfaces participating in VRRP. If a neighboring interface fails, the BFD agent on the line
card notifies the BFD manager, which in turn notifies the VRRP protocol that a link state change occurred.
Configuring BFD for VRRP is a three-step process:
1 Enable BFD globally.
2 Establish VRRP BFD sessions with all VRRP-participating neighbors.
3 On the master router, establish a VRRP BFD sessions with the backup routers. Refer to
Establishing Sessions with All VRRP
Related Configuration Tasks
• Changing VRRP Session
• Establishing Sessions with OSPF
Neighbors.
Parameters.
Neighbors.
Bidirectional Forwarding Detection (BFD) 187