Dell C9000 Series Networking Configuration Manual page 501

PeGi 255/3/42
PeGi 255/3/43
PeGi 255/3/44
PeGi 255/3/45
PeGi 255/3/46
PeGi 255/3/47
PeGi 255/3/48
To view which interfaces are enabled for Layer 3 data transmission, use the show ip interfaces brief
command in EXEC Privilege mode. In the following example, TengigabitEthernet interface 1/5 is in Layer 3
mode because an IP address has been assigned to it and the interface's status is operationally up.
Dell#show ip interface brief
Interface
TengigabitEthernet 1/0
TengigabitEthernet 1/1
TengigabitEthernet 1/2
TengigabitEthernet 1/3
TengigabitEthernet 1/4
TengigabitEthernet 1/5
TengigabitEthernet 1/6
TengigabitEthernet 1/7
TengigabitEthernet 1/8
To view only configured interfaces, use the show interfaces configured command in the EXEC
Privilege mode.
To determine which physical interfaces are available, use the show running-config command in EXEC
mode. This command displays all physical interfaces available on the line cards.
Dell#show running
Current Configuration ...
!
interface TengigabitEthernet 9/6
no ip address
shutdown
!
interface TengigabitEthernet 9/7
no ip address
shutdown
!
interface TengigabitEthernet 9/8
no ip address
shutdown
!
interface TengigabitEthernet 9/9
no ip address
shutdown
Down Auto
Up 1000 Mbit Full
Up 1000 Mbit Full
Up 1000 Mbit Full
Down Auto
Up 10
Up 10
IP-Address OK? Method
unassigned NO
unassigned NO
unassigned YES Manual
unassigned YES Manual
unassigned YES Manual
10.10.10.1 YES Manual
unassigned NO
unassigned NO
unassigned NO
Auto --
--
--
--
Auto --
Status
Manual administratively down
Manual administratively down
up
up
up
up
Manual administratively down
Manual administratively down
Manual administratively down
Protocol
down
down
up
up
up
up
down
down
down
Interfaces 501