Filtering Bgp Routes Using Route Maps; Filtering Bgp Routes Using As-Path Information - Dell C9000 Series Networking Configuration Manual

Filtering BGP Routes Using Route Maps

To filter routes using a route map, use these commands.
1 Create a route map and assign it a name.
CONFIGURATION mode
route-map map-name [permit | deny] [sequence-number]
2 Create multiple route map filters with a match or set action.
CONFIG-ROUTE-MAP mode
{match | set}
For information about configuring route maps, refer to
3 Return to CONFIGURATION mode.
CONFIG-ROUTE-MAP mode
exit
4 Enter ROUTER BGP mode.
CONFIGURATION mode
router bgp as-number
5 Filter routes based on the criteria in the configured route map.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} route-map map-name {in | out}
Configure the following parameters:
• ip-address or peer-group-name: enter the neighbor's IP address or the peer group's name.
• map-name: enter the name of a configured route map.
• in: apply the route map to inbound routes.
• out: apply the route map to outbound routes.
To view the BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode.
To view a route map configuration, use the show route-map command in EXEC Privilege mode.
Filtering BGP Routes Using AS-PATH
Information
To filter routes based on AS-PATH information, use these commands.
1 Create a AS-PATH ACL and assign it a name.
CONFIGURATION mode
Access Control Lists (ACLs).
Border Gateway Protocol IPv4 (BGPv4) 237