•
Configure an IP address and MAC address mapping for an interface.
CONFIGURATION mode
arp ip-address mac-address interface
•
ip-address: IP address in dotted decimal format (A.B.C.D).
•
mac-address: MAC address in nnnn.nnnn.nnnn format.
•
interface: enter the interface type.
•
For the Management interface, enter the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1 and the port range is 0.
•
For a Port Channel interface, enter the keywords portchannel then a number. The range is
from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/
port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port
information.
•
C1048P (port extender) 1 Gigabit Ethernet interfaces use the following command syntax:
interface peGigE pe-id/pe-stack—unit-id/port-number
where pe-id is a port-extender ID number from 0 to 255
pe-stack-unit-id is a PE stack-unit number from 0 to 7
Example of the show arp Command
These entries do not age and can only be removed manually. To remove a static ARP entry, use the no arp
ip-address command.
To view the static entries in the ARP cache, use the show arp static command in EXEC privilege mode.
Dell#show arp
Protocol
Address
--------------------------------------------------------------------------------
Internet
10.1.2.4
Dell#
Configuring ARP Inspection Trust
Use the arp-inspection-trust command to specify a port or an interface as trusted so that ARP frames
are not validated against the binding table. By default, this feature is disabled.
•
Enable ARP learning via gratuitous ARP.
INTERFACE Mode
INTERFACE PORT-CHANNEL Mode
INTERFACE PORT EXTENDER Mode
Age(min) Hardware Address
17
08:00:20:b7:bd:32
Interface VLAN CPU
Ma 1/0
-
CP
IPv4 Routing
555