HP 1650B Programming Reference Manual page 278

XPATtern
XPATtern
Command Syntax:
where:
Example:
The XPATtern command allows you to construct a pattern recognizer
term for the X marker which is then used with the XSEarch criteria and
deals with only one label at a time, a complete specification could require
several commands.
When the value of a pattern is expressed in binary, it represents the bit
values for the label inside the pattern reco @zer term. In whatever base
is used, the value must be between 0 and 2
more than 32 bits. Because the
don't cares, it is handled as a string of characters rather than a number.
The XPATtern query, in pattern marker mode, returns the pattern
specification for a given label name. In the time marker mode, the query
returns the pattern under the X marker for a given label. If the X marker
is not placed on valid data, don't cares (XX...X) are returned.
:: = string of up to 6 alphanumeric characters
: : = "{#B(O~l~X}... 1
OUTPUT XXX; ":MACHINEl:TWAVEFORM:XPATTERN
since a label may not have
1,
labelqattem > parameter may contain
c
<label-name >, -z label-pattern >
. I I
. . }"
Programming Reference
command/query
HP 1650B/HP 16518