Planet VDR-301n User Manual page 65

The following table describes the parameters:
Field
Destination
Prefix Length
Next Hop
Interface
Add Route
Delete the Selected
5.4.1.3 RIP
RIP is an Internet protocol you can set up to share routing table information with other routing devices on your LAN,
at your ISP's location, or on remote networks connected to your network via the fiber. Most small home or office
networks do not need to use RIP; they have only one router, such as the VDSL2 Router, and one path to an ISP.
In these cases, there is no need to share routes, because all Internet data from the network is sent to the same
ISP gateway. You may want to configure RIP if any of the following circumstances apply to your network:

Your home network setup includes an additional router or RIP-enabled PC (other than the VDSL2 Router).
The VDSL2 Router and the router will need to communicate via RIP to share their routing tables.

Your network connects via the fiber to a remote network, such as a corporate network. In order for your
LAN to learn the routes used within your corporate network, they should both be configured with RIP.

Your ISP requests that you run RIP for communication with devices on their network.
Description
Enter the IPv6 address of the destination device.
Enter the prefix length of the IPV6 address.
Enter the IPv6 address of the next hop in the IPv6 route to the
destination address.
The interface for the specified route.
Click it to add the new static route to the IPv6 Static Route Table.
Select a row in the IPv6 Static Route Table and click it to delete the row.
Figure 5-44 RIP
65
User Manual of VDR-301N