Planet VDR-301n User Manual page 63

5.4.1.1 Static Route
Click Static Route in the left pane and the page shown in the following figure appears. This page is used to
configure the routing information. You can add or delete IP routes.
The following table describes the parameters:
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Figure 5-41 Static Route
Description
Click it to enable/disable the selected route or route to be added.
The network IP address of the subnet. The destination can be specified
as the IP address of a subnet or a specific host in the subnet. It can also
be specified as all zeros to indicate that this route should be used for all
destinations for which no other route is defined (this is the route that
creates the default gateway).
The network mask of the destination subnet.
The IP address of the next hop through which traffic will flow towards the
destination subnet.
Defines the number of hops between network nodes that data packets
travel.
The WAN interface to which a static routing subnet is to be applied.
Add a user-defined destination route.
63
User Manual of VDR-301N