Remove the Lower Feed/LNB
4
Follow the instructions below to extract the LNB
assembly.
a. For reference later, depress the belt to note
the current belt tension (see
b. Using a 2.5 mm ball-end hex wrench, loosen
the four hex screws securing the motor in
place (see
Figure
c. Slide the motor to relieve belt tension. Then
unfasten the belt from the reflector's hub and
the motor pulley (see
aside in a safe place.
6
Figure
8).
7).
Figure
8). Set the belt
Figure 7 Motor Screws
Motor
Screw (x4)
Motor
Figure 8 Motor Belt
Hub
Pulley
Belt