Table of Contents
Advertisement
Mount the Counterweight
10
Follow the instructions below to mount the
counterweight and reinstall the radome.
a. Slowly tilt the reflector so that it points nearly
straight upwards (see
b. Peel off the release liner from the double-
sided adhesive tape on the underside of the
counterweight.
c. Mount the supplied counterweight onto the
subreflector, as shown in
d. Using a 1/16" hex wrench, tighten the two set
screws to secure the counterweight in place
(see
Figure
29).
16
Figure
29).
Figure
29.
Figure 29 Counterweight/Set Screws
Set Screw
(x2)
Subreflector
Counterweight
Advertisement
Table of Contents
