Table of Contents
Advertisement
Continued
6
e. Orient the LNB assembly and upper feed to
ensure the RF connectors on the LNB will be
facing upward (approximately aligned with
the gyro bracket), while maintaining the
mounting hole alignment with the pins and
phase cards (see
Figure
f. Gently press the LNB assembly straight into
the rear of the reflector, ensuring the phase
cards and mounting pins remain aligned.
These cards fit snugly into the mounting
holes; some friction is expected (see
Figure
17).
IMPORTANT!
To avoid damage, be sure to press the phase
cards straight into the mounting holes. Do not
apply lateral pressure or shimmy the
assembly into place.
g. While holding the LNB assembly in place,
insert four supplied #8 hex screws into the
mounting holes on the front of the reflector
(see
Figure
18).
h. Using a 9/64" ball-end wrench, tighten the
screws in a cross pattern.
Mount the LNB Assembly
17).
Figure 17 Assembly Mounting
Belt
Figure 18 Hex Screws on Reflector
Gyro Bracket
RF Connectors
#8 Hex
Screw (x4)
11
Advertisement
Table of Contents
