Remove The Radome - KVH Industries Ka Tri-Americas LNB Installation Manual

Remove the Radome

2
Follow the instructions below to remove the
radome.
Standard Dome Version
a. Using a #2 Phillips screwdriver, remove the
six #10-32 screws securing the radome to the
baseplate (see Figure
b. Carefully lift the radome straight up off the
antenna. Then set it aside in a safe place.
TIP: If you keep the radome topside, secure it with a
lanyard to prevent it from falling overboard.
35" (90 cm) Dome Version
a. Using a #2 Phillips screwdriver, remove the
eight #10-32 screws securing the radome to
the baseplate (see
b. Carefully lift the radome straight up off the
antenna. Then set it aside in a safe place.
TIP: If you keep the radome topside, secure it with a
lanyard to prevent it from falling overboard.
4
2).
Figure 3).
Figure 2 Radome Screws (standard dome version)
Radome
#10-32
Screw (x6)
Baseplate
Figure 3 Radome Screws (35" dome version)
Radome
#10-32
Screw (x8)
Baseplate