Step 1 - Remove the Radome
For your own safety, be sure to disconnect
power from all wired components before
performing this procedure.
a. Disconnect all power from the TracPhone
system– turn off and unplug the ICM
(V3-IP/V3-HTS) or control unit and modem
(V3).
b. Remove the three #10-32 screws securing the
radome to the baseplate (see Figure 1). Set the
radome and screws aside in a safe place.
Step 2 - Identify the Gyro Location
Identify the location of the gyro you need to
replace (see Figure 2). Then follow the associated
instructions in Step 3:
Gyro
Go to Page:
Azimuth
3
Elevation
4
Skew
5
2
CAUTION
Figure 1: Radome Screws
#10-32 Screw (x3)
Figure 2: Gyro Locations (V3-IP Shown)
Azimuth
Elevation
Skew