Table of Contents
Advertisement
Continued
4
d. While holding the LNB assembly, fully
loosen the four #8 hex screws on the front of
the reflector using a 9/64" ball-end hex
wrench (see
Figure
e. Using needle-nose pliers, extract the four hex
screws.
f. Carefully pull the LNB assembly straight
backward.
IMPORTANT!
To avoid damage, extract the bracket straight
backward; do not move the assembly from
side to side.
g. Using a 3/32" ball-end hex wrench, remove
the two #4 hex screws securing the lower feed
to the motor bracket (see
h. Using a 7/64" ball-end hex wrench, remove
the #6 hex screw securing the lower feed/
LNB to the motor bracket (see
i.
Remove the lower feed/LNB and the lower
feed gasket (shown in
from the motor bracket.
Remove the Lower Feed/LNB
9).
Figure
10).
Figure
10).
Figure 13 on page
9)
Figure 9 Hex Screws on Reflector
Figure 10 Lower Feed Screws
#4 Hex
Screw (x2)
#6 Hex
Screw
#8 Hex
Screw (x4)
7
Advertisement
Table of Contents
