Table of Contents
Advertisement
Continued
8
f. Tuck the motor cable and gyro wires between
the LNB and the motor (see
g. While aligning the end of the cable braid with
the right edge of the motor, tuck the cable
harness between the LNB and motor (see
Figure
25)
h. Secure the cable harness to the LNB with the
P-clip you removed earlier, and a supplied
#8-32 screw, washer, and nut (see
Ensure the P-clip is mounted on the inside of
the LNB (facing the reflector).
i.
Using a supplied tie-wrap, secure the cable
harness and gyro wires to the LNB, as shown
in
Figure 25
j.
Route the cables around the LNB, as shown
in
Figure
26.
k. Loosely secure the RF cables to the LNB plate,
as shown in
Figure
l.
Rotate the LNB assembly and ensure the
cables do not contact the limit switch.
m. Tighten the tie-wrap securing the RF cables to
the LNB plate (see
14
Reconnect and Dress Cables
Figure
25).
Figure
25).
27.
Figure
27).
Figure 25 P-clip/Tie-wrap Mounting
#8-32 Screw,
Washer & Nut
Cable
Tie-wrap
Braid End
Figure 26 Cable Harness/Cable Routing
Routed
Cables
Tie-wrap
Figure 27 LNB Plate Tie-wrap
Cables
Limit
Switch
Tie-wrap
LNB Plate
P-clip
Cable
Harness
P-clip
Advertisement
Table of Contents
