Table of Contents
Advertisement
Reconnect and Dress Cables
8
Follow the instructions below to reconnect and
dress the cables.
a. Using a 7/16" open-end wrench, connect and
tighten the RF1, RF2, RF3, and RF4 cables to
the LNB exactly as shown in
Figure
23. Tighten the RF1 cable first. Then
tighten each of the remaining connectors,
ensuring the wire of each connector contacts
the flat of the previous connector when
tightened.
b. Place the supplied connector plate onto the
LNB, as shown in
Figure
c. Firmly secure the connector plate onto the
LNB by inserting a supplied thin tie-wrap
through the LNB mounting holes (shown in
Figure
23).
d. Rotate the LNB assembly to ensure there is no
contact between the connector plate and the
limit switch cable (see
contact, adjust the RF cables and connector
plate to maximize clearance. Then retighten
the tie-wrap to resecure the connector plate.
e. Trim and remove the excess tie-wrap length.
Figure 22
and
24.
Figure
24). If there is
Figure 22 RF Connector Orientation
RF1
Figure 23 LNB Cables/Mounting Holes
RF1
RF2
Mounting
Hole (x2)
Figure 24 Connector Plate Mounting
Limit Switch
Cable
RF4
RF3
Connector
Plate
Thin
Tie-wrap
13
Advertisement
Table of Contents
