Table of Contents
Advertisement
Continued
5
b. Using a 3/32" ball-end hex wrench, carefully
secure the new lower feed/LNB onto the
motor bracket with two supplied #4 hex
screws (see
Figure
12).
c. Using a 7/64" ball-end hex wrench, secure
the new lower feed onto the motor bracket
with one supplied #6 hex screw (see
Figure
12).
d. Remove the second lower feed cover screw
(see
Figure 11 on page
cover.
IMPORTANT!
To avoid damage, handle the new lower
feed/LNB extremely carefully once you
remove the protective cover (see
page
8). All three phase cards on the new
lower feed/LNB must remain intact to
complete the installation.
e. Press the supplied lower feed gasket into the
grooves on the lower feed (see
Install the New Lower Feed/LNB
8). Then remove the
Figure 11 on
Figure
13).
Figure 12 Lower Feed Screws
#4 Hex
Screw (x2)
#6 Hex
Screw
Figure 13 Phase Cards
Gasket
Phase
Groove
Card (x3)
9
Advertisement
Table of Contents
