6
Removing the Hatch and Radome
Follow these steps to remove the service hatch and
radome to access the antenna.
a. Using a #2 Phillips screwdriver, remove the
eleven M4 screws securing the service hatch to
the baseplate
b. Using a #2 Phillips screwdriver, remove the
eight #10-32 Phillips screws securing the
radome to the baseplate (see Figure 11).
Carefully lift the radome straight up until clear
of the antenna assembly and set it aside in a
safe place.
If you keep the radome topside, secure it with a
lanyard to prevent it from falling overboard.
Also, do not place the radome on a hot steel
deck – the heat may warp the radome.
IMPORTANT!
If necessary, use the two 0.5" (12.5 mm)
holes in the antenna frame (see Figure 12) to
hoist the antenna to its mounting location.
DO NOT use any other structure inside the
antenna — doing so might damage the
antenna.
Figure 10: Remove the Service Hatch
Service Hatch
M4 Screw (x11)
Figure 11: Removing the Radome
Radome
#10-32
Screw (x8)
Baseplate
Figure 12: Antenna Hoisting Holes
Hoisting Hole (x2)
9