Delime Instructions - Jackson crew series Installation, Operation And Service Manual

OPERATION
To proceed with the delime operation, fill the dishmachine with the amount of delime solution recommended by the chemical
supplier. The tank capacities of the machine can be found in the Specifications section of this manual.
After the chemicals are added, perform the following steps:
1. Flip the NORMAL/DELIME switch to DELIME.
2. Disconnect or turn off chemical feeder pumps.
3. Close all doors.
4. Press the START button and run the machine for the length of time required by the chemical supplier.
5. Press the START button to shut the unit off.
6. Open the door and step away for 5 minutes.
7. Inspect the inside of the unit to determine if expectations have been met. If not, try running the delime
solution through the unit for more time.
8. Once clean, drain the machine completely.
9. Close the door.
10. Refill the unit.
11. Press the START button and run the unit in Manual for 10 minutes.
12. Press the START button to turn off the unit.
13. Open the front door.
14. Drain the unit.
15. Flip the NORMAL/DELIME switch to NORMAL.
16. The machine is ready to use.
This equipment is not recommended for use with deionized water or other aggressive fluids. Use of deionized
water or other aggressive fluids will result in corrosion and failure of materials and components. Use of
deionized water or other aggressive fluids will void the manufacturer's warranty.
23

DELIME INSTRUCTIONS

07610-003-78-18-N