Jackson JFT Specification Sheet

Flight Machine
Models
JFT
Standard Features
• Uses 140 gallons (530 ltrs) of water per hour with sanitizing
hot water rinse
• All tanks and hoods constructed from 16 gauge 304 stainless
steel with a No. 3 finish and heliarced welded
• Stainless steel frame, legs and feet
• Two tank rackless conveyor shall have a maximum capacity
of 17,101 dishes per hour at an NSF rated belt speed of 8.63
feet per minute. At 6.4 feet (2 m) per minute capacity will be
12,726 dishes per hour.
• Belt width of 29" (737 mm) and a maximum clearance of 25"
(635 mm) throughout the machine
• Enclosure panels, hood and doors are stainless steel and dou-
ble wall insulated to reduce heat dissipation, outside surface
temperatures, and noise pollution
• Insulated access doors for removal, cleaning and servicing
• V-shape tank(s) design to increase visibility and accessibility
for cleaning as well as insure complete tank draining
• Heated power rinse zone uses fresh rinse water a second
time to provide pristine results
• A sequential digital temperature readout of each tank
housed in the door of the electrical control panel. The read-
outs will constantly display the temperature of the prewash,
wash, power rinse and final rinse in 5 second intervals
• A ball valve in the drain line of each tank and interconnected
to a common machine drain connection at the load end of
the machine
• Each tank will be automatically filled and maintained by a
water level float. Water will be automatically added to the
machine when required
Highway 25E Tel: 606-523-9795
P. O. Box 1060 Tel: 1-888-800-5672
Barbourville, KY 40906 Fax: 606-523-9196
E-mail: info@jacksonmsc.com
• Block manifold wash arms are easy to remove, clean, and
replace with non-clogging convex wash arm jets
• Large, removable scrap screens
• Self draining stainless steel pumps, impellers, and hous-
ings are readily accessible and serviceable
• Conveyor belt drive operates at two speeds and is pro-
tected by an overload safety device and an automatic
shut-down actuator
• Each door is equipped with a door safety switch to pre-
vent it from running when the door(s) are open. If a door
is opened during operation the switch will immediately
shut down the machine
• Operator activated start-stop switches on both the load
and unload ends and the control panel
• Removable insulated panels to enclose the unit down
to the base frame on both the front and rear of the
machine
• A single, built-in 18" (457 mm) diameter indirect vent
connection with a 0.19 HP exhaust fan mounted in a
cleanable cross duct on the machine for condensate
removal and indirect vent connection
• 3" minimum wall clearance
• Service access from front of machine
www.jacksonmsc.com
07610-002-85-11 (8/07)
Project
Item
Quantity
CSI Section 11400
Approval
Date
Options
Blower dryer
Additional wash section
Additional load module
Additional unload module
25' (8 m) wash down
hose - mounted
Electrical connection with
circuit breakers
Dual point electrical connection
Low profile doors
Flanged feet
Multiple conveyor peg choice
Drain at load or unload end