Dispenser - SATO WS408TT Technical Manual

2 Accessories Installation

2.2 Dispenser

A dispenser automatically removes the liner from the printed label. The dispenser
sensor detects if a peeled label is taken away.
To install a dispenser:
Step 1. Remove the tear bar, top cover and middle frame
This part describes how to dismantle your printer.
1. Open the top cover.
2. Push the Module Release Latch to open the print module.
3. Loosen and remove the two screws on each side of the tear bar to reveal the
screw holes. You'll use those two screw holes to secure the dispenser later.
13
Dispenser
WS4-TT-r01-30-12-16TM