Dispenser Mode (Pw208Nx Only); Switching To The Dispenser Mode - SATO PW208NX Operator's Manual

Before You Start

1.7 Dispenser Mode (PW208NX only)

1.7.1 Switching to the Dispenser Mode

• When setting up the dispenser unit, be careful not to get cut your finger with the cutter.
Use only the supply products specified by SATO.
Before use, check the printer operations with the media to be used.
1
Open the top cover.
Push the cover open button ().
Open the top cover ().
2
Set up the dispenser unit.
Slide the dispenser lever (), and
set up the dispenser unit ().
3
Load the media.
Pull out the media for one sheet, and then load
the media so that the surface touches the print
head.
If the media is difficult to load, rewind the media
roll so that the two ends of the roll become even.
4
Close the top cover.
Make sure the media fit between the dispenser
unit and top cover, and close the top cover so
that it clicks shut.
The print mode
switches to Dispenser mode after setting up the
dispenser unit.
30 Mobile printer PW208NX/PW208mNX
(
 page 52) automatically
②
①
②
①