SATO WS408TT Technical Manual page 35

3 System Mode
16. Darkness
The current darkness.
17. Print Method
It is either thermal transfer (TT) or direct thermal (DT) printing. TT requires
ribbons and DT doesn't.
18. Print Length
The total print length.
19. Cut Count
It counts the times the cutter cuts.
20. RS232 Protocol
It lists RS-232C settings in the following order: baud rate, data length, parity check,
stop bit and flow control.
21. Media
The media type in use.
22. Reprint After Error
When it is enabled, the printer reprints the label after the error fixed if it is printed
incorrectly due to the error.
23. Backfeed Enabled/Disabled
Enable or disable backfeed during the printing process. When it is enabled, the
printer moves the paper forward in a predefined length 1 second after printing,
and pulls the paper back in a predefined length once the printing begins again.
When it is disabled, the printer won't move the paper at all.
24. Cutter Enabled/Disabled
Enable or disable the cutter during the printing process.
25. Dispenser Enabled/Disabled
Enable or disable the dispenser during the printing process.
26. Cutter/Dispenser Offset
Move the cutting line or the peeling position forward or backward. The value in
the angle brackets is the offset unit.
27. IP Address
The static IP address of the printer. The default value is "192.168.1.1".
28. Subnet Mask
32
Self-Test and Dump
mode
WS4-TT-r01-30-12-16TM