SATO WS408TT Technical Manual page 20

2 Accessories Installation
Step 3. Test the dispenser
This part describes how to use the dispenser to peel the liner.
1. Press the switch lock on the Media Roll Holders to slide them outward and
place the media roll between the holders. Adjust the media roll so its print
side is facing up, and make sure it is clamped tightly by the holders.
2. Press the Lock button on the Media Guides to slide them outward.
3. Pull the media until it reaches out of the printer. Put the media under the
Media Shaft and center it between the Media Guides.
4. Remove 1-3 labels from the liner at the start of the media.
5. Close the print module and press down firmly at its both sides, until you hear a
click.
6. Thread the liner into the slot of the dispenser, until the first label touches the
dispenser plate.
7. Close the dispenser and close the top cover.
8. Send a print job or press the FEED button to test if the dispenser works.
17
Dispenser
WS4-TT-r01-30-12-16TM