SATO WS408TT Technical Manual page 15

2 Accessories Installation
Step 3. Test the cutter
This part describes how to use the cutter to cut your label.
1. Press the switch lock on the Media Roll Holders to slide them outward and
place the media roll between the holders. Adjust the media roll so its print
side is facing up and make sure it is clamped tightly by the holders.
2. Press the Lock button on the Media Guides to slide them outward.
3. Pull the media until it reaches the edge of the cutter plate. Put the media
under the Media Shaft and center it between the Media Guides.
4. Thread the media into the slot of the cutter.
5. Close the print module and press down firmly at its both sides, until you hear a
click.
6. Close the top cover.
7. Send a print job or press the FEED button to test if the cutter works.
12
Cutter
WS4-TT-r01-30-12-16TM