SATO WS408TT Technical Manual page 18

2 Accessories Installation Dispenser
6. Loosen and remove the two screws on each side of the Media Roll Holders.
7. Remove the middle frame along with the top cover.
Step 2. Connect and secure the dispenser to your printer
This part describes how to thread the dispenser cable and wire, connect them to
the main board and secure the dispenser and reinstall the part you took off.
1. Thread the dispenser wire through the square hole to the right of the print
module.
2. Plug the dispenser connector to the J14 on the main board. J14 is a red port
WS4-TT-r01-30-12-16TM
15