Kyocera KM-2540 Service Manual page 59

Maintenance
item No.
Rewriting FAX program
U926
Description
Downloads the fax program and fax fonts when installing an fax kit.
Purpose
To run when upgrading the fax program and fax fonts.
Setting
1. Press the power key on the operation panel, and after verifying the power indicator has gone off, switch
off the main power switch.
2. Remove two screws and remove the right upper plate lid.
3. Insert Compact Flash in a notch hole of the machine.
4. Turn the main power switch on.
5. Enter the maintenance item.
6. Press the start key.
7. Select [FAX PROGRAM/FONT] and press the start key.
Downloading of the fax program starts and the result shown below is displayed.
If the operation was successful:
EXECUTE 0100
CHECK SUM ****
CODE 0000
If the operation failed:
EXECUTE 0100
CHECK SUM ****
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
8. Then, downloading of the fax fonts starts and the result shown below is displayed.
If the operation was successful:
EXECUTE 0100
CHECK SUM ****
CODE 0000
If the operation failed:
EXECUTE 0100
CHECK SUM ****
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
See Error Codes for Operation U917 and U926 on P.1-3-36.
9. Press the power key on the operation panel, and after verifying the power indicator has gone off, switch
off the main power switch.
10. Remove the Compact Flash from the machine.
11. Refit the right upper plate lid.
Description
3LH
1-3-37