Select/Set Button - Siemens SCALANCE X-200 Configuration Manual

Menus in the WBM
5.1 The System menu
5.1.8

Select/Set Button

Select/Set Button Configuration
On this page, you can configure the functions of the SET button.
Figure 5-8
Restore Factory Defaults
Here, you decide whether the device is reset to factory defaults when the SET button is
pressed.
Enable/Disable Redundancy Manager
Here, you decide whether the redundancy manager can be switched on and off by pressing
the SET button.
Set Fault Mask
Here, you decide whether the information of the "Fault Mask" is used when the SET button is
pressed.
60
Select/Set Button Configuration
Configuration Manual, 03/2015, C79000-G8976-C285-06
SCALANCE X-200