Connection To Profinet Io - Siemens SCALANCE X-200 Configuration Manual

Connection to PROFINET IO

connection via STEP 7
The SCALANCE X-200 IE switches are also suitable for use in a network with PROFINET
IO. The devices must be linked into PROFINET IO using STEP 7.
How this connection is achieved is not covered in these operating instructions but is
explained in the STEP 7 help.
Configuring interrupts in STEP 7 V5
The configuration of the "C-PLUG error" and "Redundant power supply" interrupts is a
special feature among the SIMATIC net devices. For this reason, you will not find any
information in the STEP 7 help relating to configuration of these two interrupts.
The configuration of these interrupts is described in the following section.
Further information about PROFINET IO
The system manual PROFINET System Description provides an overview of the PROFINET
communications system. You will find this manual on the Product Support pages under the
following entry ID:
19292127 (http://support.automation.siemens.com/WW/view/en/19292127)
Note
If an X-200 that was previously configured via PROFINET IO needs to be operated without
PROFINET functionality, you will need to reset the device to its factory defaults. For more
detailed information, refer to section "The System > Restart & Defaults (Page 50) menu".
SCALANCE X-200
Configuration Manual, 03/2015, C79000-G8976-C285-06
7
155