Cord Multi (Cumulative) Flash Mode; Measuring - Sekonic SPEEDMASTER L-858D Operating Manual

5-2-4

Cord Multi (Cumulative) Flash Mode

This Measuring Mode is used when the light generated by the flash at one time is
inadequate for the desired F-stop setting. Repeated flash pops can be accumulated
until the desired F-stop value is displayed. The measured value (F-stop) is displayed
for each trigger of the flash. The cumulative count is displayed in the Status/Title
field. The cumulative count is infinite. Up to 99 times is displayed in the Status/
Title field, however, the cumulative count returns to 0(zero) for more than 100 times
(0=100, 1=101, 2=102, etc.).
1)

Measuring

Operation
1.
Connect the synchro cord (sold
separately), which is connected to
the flash, to the meter.
Connect the synchro cord (sold separately) to
the meter's Synchro Terminal
2.
Touch the Measuring Mode Icon on
the Measuring Screen.
The Measuring Mode Screen is displayed.
3.
Touch the icon (
When it is selected, the display changes to the Measuring Screen.
Measuring
Mode Icon
4.
Set the light receiving method.
Switch to the Incident light, extended lumisphere (
reflected light. ( P32, P37)
( P195)

.
b
) on the Measuring Mode Screen.
Measuring Screen
Synchro Cord (sold separately)
Synchro Terminal
Measuring Mode Screen
)/retracted lumisphere (
87
5. Measuring
b
Measuring Screen
), or