852] System Alarm Assignments - Samsung OfficeServ 7000 Series Programming Manual

[ 852] SYSTEM ALARM ASSIGNMENTS

2 5 2 B
This MMC allows the assignment of system alarms to ring and display on stations that
have an Alarm key assigned. The Alarm key is assigned in MMC 722(Station Key Pro-
gramming). Alarm key programming is tenant wide(tenants 1 and 2). Alarms not pro-
grammed to report to the system Alarm key will still be retained in the maintenance alarm
buffer for Alarm Reporting(MMC 851). The alarm buffer holds up to 100 alarms on a First
In-First Out(FIFO) basis. Pressing the Alarm key will silence the audible alarm until an-
other alarm is generated by the system. Alarm conditions that have multiple causes(e.g.,
PRI errors and synchronization loss) will print all associated alarm information if an SIO
port is programmed as an ALARM port. The specific fault alarm data can be displayed via
MMC 851, System Alarm Reporting.
Alarm Notification
Alarm Notification Off/On(0/1) determines if the alarm provides a visual and audi-
ble notification to the System Alarm key station(s). Pressing the System Alarm
key and the release key will silence the audible alarm only at the station that
pressed the System Alarm key and the release key. See alarm displays table for
assignments.
Alarm Code Definitions:
No Code
- MJA--
01 MJA01
02 MJA02
03 MJA03
04 MJA04
05 MJA05
06 MJA06
08 MJA08
Samsung Business Communications
Alarm Name
MCP2 Error System Fault
POWER MCP2 restart process has been executed via power on
Restart restart.(POR)
Soft Restart MCP2 restart process has been executed via button reset.
Mem Reset The system RAM has been cleared via manual program-
ming(PCMMC or KMMC) resulting in a system reset.
MCP Reset The MCP2 has software exception error.
Alarm data = Reason
- BUS ERR: Restart Bus Error
- ADDR.ERR: Restart Address Error
- ILLEGAL: Restart Illegal Opcode
- ZERO DIVID: Restart Zero Divide
- PRIVILEGE: Restart Privilege Violation
- ENDL LOOP: Restart Endless Loop
LCP Reset The SCP2 or LCP2 has reset
Alarm data = Cabinet(1, 2 or 3)
PCM Switching A fault has occurred in the Switching Control
Alarm data = MCP BASE, ESM: 1, ESM: 2 or ESM: 3
FAN Out of A FAN does not work.
Order
CHAPTER 2. MMC Programming
Definition
2-397