Samsung OfficeServ 7000 Series Programming Manual page 423

No Parameter
07 VERSION
10 WBS TX PWR
19 CLR WBSREG
20 MAX AP CH.
21 WLAN SWTCH
22 DELETE SIP
W BS PARAMETER
1 1 0 0 B
There are two types of WBS, the COMBO AP and BASIC AP. A system cannot use both
types of WBS at the same time. The AP type to be used can be set in MMC 849. Depending
on the selected AP type, this program displays COMBO AP(CWBS), and BASIC AP
(BWBS).
When using COMBO AP(CWBS)
WBS24 COMBO is connected to a WLI card. Up to three WLI cards can be installed.
(A single WLI card can connect up to eight WBS24 COMBOs.)
When using BASIC AP(BWBS)
WBS24 BASIC is connected to the system through the network and requires an MGI
port to provide tone and call path connection.
No Parameter
00 IP ADDRESS
01 GATEWAY
02 NET MASK
03 MAC ADDR
04 VERSION
05 STATUS
06 RF CH.
07 TX POWER
09 TIME ZONES
10 PARA CLR
WBS NAME
Samsung Business Communications
Description
WLAN module version.
TX POWER of all WBSs.
If AP type is not Commercial AP, this option can be shown.
Initializes registration data of all WBSs.
If AP type is not Commercial AP, this option can be shown.
Set the maximum channel number of AP
If AP type is not Commercial AP, this option can be shown.
Support WLAN switch function
In case that AP type is not WBS COMBO, this option can
be shown
Select whether SIP Protocol will be used or not adapting
WLAN phone.
Description
WBS24 IP address for Ethernet.
Gateway address of the WBS24 Network.
Netmask of the WBS24 Network.
MAC address of WBS24 received by the system
when WBS24 is connected.
WBS24 software version.
Alive operation status.
RF channel no. used by each WBS24.
TX POWER of each WBS.
Time zone service for each WBS
Initializes WBS registration data.
It is available to enter the name corresponding to
each WBS. Maximum 11 characters can be en-
CHAPTER 2. MMC Programming
(continued)
Default
Version
DEFAULT
NO
00
DISABLE
DISABLE
Default
0.0.0.0
0.0.0.0
255.255.255.0
FFFF FFFF FFFF
Version
OFF
1, 6, or 11
DEFAULT
00:00
NO
NONE
2-381