Slim Select Bay Module - Toshiba PORTEGE S100 Maintenance Manual

4 Replacement Procedures
4.8

Slim select bay module

Removing the Slim select bay module
To remove the slim select bay module, follow the steps below and refer to Figure 4-7.
The explanation and figure shown below are the optical drive removing/installing. As for
other module, the procedure is same.
CAUTION: Do not put fingers in the slim select bay module. It may cause injury.
1. Remove the following screw securing the latch and drive the removed screw into the
screw hole. (The slim select bay is unlocked.)
• M2.5×4B FLAT HEAD screw
2. While sliding the latch toward the arrow direction in the figure, slide the slim select
bay module outward to disconnect it from the system board.
4-18
Downloaded from LpManual.com Manuals
Slim select bay module
Figure 4-7 Removing the slim select bay module
×1
Latch
Screw hole
PORTEGE S100 Maintenance Manual (960-508)
4.8 Slim select bay module
M2.5×4B FLAT HEAD