Sw Board - Toshiba PORTEGE S100 Maintenance Manual

4.14 SW board

4.14 SW board
Removing the SW board
To remove the SW board, follow the steps below and refer to Figure 4-19.
1. Remove the following screw and switch cover.
• M2×3S
2. Turn up the insulator and disconnect the SW cable from the connector CN3260 on
the system board.
3. Remove the following screws and SW board.
• M2×3S
M2×3S S-FLAT HEAD
PORTEGE S100 Maintenance Manual (960-508)
Downloaded from LpManual.com Manuals
S-FLAT HEAD screw
S-FLAT HEAD screw
M2×3S S-FLAT HEAD
Switch cover
SW board
Figure 4-19 Removing the switch board
4 Replacement Procedures
×1
×2
M2×3S S-FLAT HEAD
SW cable
CN3260
Insulator
4-35