Toshiba PORTEGE S100 Maintenance Manual page 247

4.11 Memory module
2. Press the two latches outward and remove the memory module.
Latch
Installing the Memory module
To install the memory module, make sure that the computer is in boot mode and powered off,
follow the steps below and refer to Figure 4-14 and 4-15.
CAUTION: Do not touch the connectors on the memory module or on the computer.
1. Insert the memory module into the connector slantwise (terminal side first) and press
it to connect firmly.
CAUTION: After installing the memory module, confirm that the memory module is fixed
2. Install the keyboard support plate and secure it with the following screws.
• M2×8B
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, check that it is connected correctly.
PORTEGE S100 Maintenance Manual (960-508)
Downloaded from LpManual.com Manuals
Memory module
Figure 4-15 Removing the memory module
Dust and stains on the connectors may cause memory access problems.
with the left and right latches.
BIND screw
4 Replacement Procedures
Latch
×3
4-29