Toshiba PORTEGE S100 Maintenance Manual page 151

3.21 ONLY ONE TEST
Subtest 05
NOTE: When executing this subtest, USB test module and USB cable must be connected.
################################################################
########
################################################################
*
* 0 ............
* 1 ............
*
* 9 ............
*
****************************************************************
.... Press test number[0-1, 9] ?
PORTEGE S100 Maintenance Manual (960-508)
Downloaded from LpManual.com Manuals
Slide the switch to OFF position. Then, following message appears in the
display.
KILL SWITCH ON !!
Slide the switch to ON position. Then, following message appears in the
display.
KILL SWITCH OFF !!
After Sliding the switch to OFF position, return to the ONLY ONE TEST
menu automatically.
USB
This subtest checks if USB port works properly.
The following menu appears in the display.
ONLY ONE TEST Menu (XXXXXXXXX)
Port 0
Port 1
EXIT
Connect the USB test module and USB cable to the computer.
Input the port test number and press Enter.
OK message appears in the display if the test ends without fail.
NG message appears in the display if an error is found during the test.
Confirm the connection of cable, and then execute the test again.
Press 9 and Enter to return to ONLY ONE TESST menu.
3 Tests and Diagnostics
#######
*
*
*
*
*
*
3-53