The Basic Display Menu; Table 12 - The Basic Display Menus - Honeywell stt850 SMARTLINE User Manual

4.1.6 The Basic Display Menu

The Basic Display Menu is implemented as one long single-level menu and will "wrap around" when
it reaches the start or end of the menu. Operation is as follows:

Press the button to call up the Menu.
1. Select <Exit Menu> and press
2. Use the  and  buttons to scroll through the list of menu items.
3. Press the  button to select an item for data entry or activation. When an item is selected for
data entry or activation, the cursor will jump to the lower line of the LCD to allow editing of
the value. No action is taken against a menu item until the user presses the
4. If you want to abort a data entry operation, simply refrain from pushing any buttons for 10
seconds; the data entry operation will time out and the original value of the selected item will
be preserved.
'#' in "Screen #" indicates the screen numbers 1, 2, 3, 4, 5, 6, 7, 8
'n' in "Sensor n" indicates the Input numbers 1, 2
LCD Contrast »»»»»
Rotation Time
Enabled
Screen Rotate
Disabled
Select Screen 1 through 8
(HART/DE)
Screen #
Enabled/Disabled
(HART/DE)
Loop PV
Sensor 1
Sensor 2
Screen # PV CJ Temperature
(HART/DE) Sensor 1 Resistance
Sensor 2 Resistance
Loop Output
Percent Output
None
Screen Decimal X.X
(HART/DE) X.XX
X.XXX
Screen Units
(HART/DE)
°C, °F,°R, K
(Writable only for
TC/RTD inputs)
Range/Cal Units
(HART/DE/FF) °C, °F, °R, K
(Visible for TC and
RTD inputs only)
Page 38

to exit the Menu.
Table 12 – The
STT850 Temperature Transmitter User's Manual
Basic Display Menus
Adjust the LCD contrast level.
Range from » (1) to »»»»»»»»» (9)
Default: »»»»»»» (7)
Select to enable or disable the
automatic rotation of Screens
Select Screen to configure.
Select to enable or disable the screen
for display and configuration
Select the Process Variable (PV) that
will be shown on the screen.
Sensor Resistance is only available
for RTDs and will read 0 for
thermocouples
Select the PV decimal resolution to be
shown on selected screen from list.
Choose appropriate engineering units
from list
Select the ranging and calibration
temperature units

button.
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
Revision 3